So go ahead and download the latest firmware version for your SnapCam^™

Click me to download firmware

See, that was easy… next

Start again

Connect your Micro SD Card or Camera to your computer.

Piece of cake… next

Start again

While camera is connected via USB cable press and hold the power button to turn the camera on. This will allow the Micro SD card to be accessible on your computer.

Easy… next

Start again

Be sure to charge your camera for at least 3 hours before starting the firmware update.

Just be patient… next

Start again

1. Navigate to the finder.
2. Select the Micro SD Card
3. Do you see the FIRMWARE folder?

If YES… click hereIf NO… click here

Start again

Click filenew folder to create a new folder and name the folder FIRMWARE in all caps.

Walk in the park… next

Start again

Drag the firmware file you downloaded into the FIRMWARE folder.

That was a snap, see what we did there… next

Start again

Ensure your camera is switched on and connected. The firmware update will begin.

Super simple… next

Start again

Press and hold the power button for 3 sec. A red LED will begin flashing and the camera will make a long beep. When the flashing stops, your update will be complete!

This will take about 1 min. Do NOT operate the camera while performing update.

You are almost there… next

Start again

Please disconnect your SnapCam^™ from your computer.

Home stretch… next

Start again

You are now ready to use your SnapCam^™

Start again